New Water Service Line Installation for Kitsap County Homes and Properties

How we do new Water Service Line Installation here

On 40-foot city lots to 20-acre parcels the route is most of the job. Short and clear beats threading past a drainfield and under a pad. We walk it with you, then deal with hardpan on the uplands with the machine, and size the pipe for the demand at the far end, not the nearest.

Around the Hood Canal Bridge the typical new water service installation call is a crawlspace wet every winter; around Sinclair Inlet it's a bill or a pump that won't rest. Different symptoms, the same long poly well lines on acreage and clay on the bluffs underneath.

Two things decide new water service installation in Kitsap County: the pipe, often long poly well lines on acreage, and the dirt, clay on the bluffs. We've worked both on island drives and shoreline bluffs enough times to know what to bring when we restore.

A new line can also retire an old problem. Many Kitsap County properties still run on 1980s polybutylene by the mile with marginal pressure, and a project that needs water near Highway 3 is the moment to replace the whole feed in one run through hardpan on the uplands.

What's in the ground in Kitsap County

Every pipe material of the last century is in the ground somewhere in Kitsap, and we transition all of them to PEX or HDPE with buried-rated fittings. That geology is the reason underground water leaks are so hard to find here by eye.

Every new water service installation job is pressure tested before backfill and tied in with brass or stainless rated for burial. Interior-grade fittings corrode in clay on the bluffs; we've dug enough out from under island drives and shoreline bluffs in Kitsap County to know.

The job, step by step

A new water service installation visit to Kitsap County runs: test and backfill, then restore, then locates and permits. The middle step is where outwash in the valleys and runs from twenty feet to half a mile set the pace, and buried-rated brass and stainless is what gets it done near Sinclair Inlet.

Subdivisions and farms alike over outwash in the valleys is a different new water service installation day than a flat lot in sand. We bring buried-rated brass and stainless, shutoff valves and hydrant and the machine, and tell you up front whether every material of the last century is going to make it a long one near Point No Point.

Island drives and shoreline bluffs near the Hood Canal Bridge, long poly well lines on acreage below, clay on the bluffs around it: that's the Kitsap County version of new water service installation, and a crawlspace wet every winter is the usual first clue.

Kitsap County coverage

Our new water service installation calls in Kitsap County cover Sinclair Inlet, Liberty Bay, Point No Point and everything between. We're based in Central Kitsap, anywhere on the peninsula, every day, and we answer 24 hours a day with buried-rated brass and stainless on board.